Dock bumper dimensions
Thickness: 4 1/2"
Height: 10"
Length: 63"

HomeDock BumpersExtra Length Dock BumpersDrawing (PDF)Brochure (PDF)

Dock Bumper Model: B4510-63-A

All measurements +/- 1/8"

• Provides protection against vehicle damage to docks, buildings and cargo
• Absorbs over 80% of truck impact and shock to protect dock and building
• Leading bumper sold in the industry today
• Coverage across dock face
• Eliminates costly repairs from severe shock to docks
• Anchored through thick steel angles to provide stability and shape retention
• Additional mounting points for a secure installation
• Maintenance free

1. Bumpers: Durable Laminated Extra-Long Rubber Dock Bumper; Fabric reinforced rubber pads laminated between structural steel angles and secured with 3/4 inch (19 mm) steel supporting rods; anchor bolts protected by rubber
2. Projection from Wall: 4.5 in (114.3 mm)
3. Vertical Height: 10 in (254 mm); Vertical bolt hole centers: 6 in (152.4 mm)
4. Overall Length: 65 in (1651 mm); Bolt Hole Centers: 63 in (1600.2 mm)
5. The anchor leg of angle extends a minimum of 3" beyond the rubber surface at either end and contains two or three 13/16" anchor bolt holes as required. (Anchor bolts are supplied separately.)
6. The finish for exposed metal parts shall be Black, or hot dipped galvanized. (Galvanized has additional cost).
7. Bumper to hold dimensions of 63 in x 4.5 in x 10 in (LWH) - bumper rubber dimensions to be 4.5 inx 10 in x 59 in (WHL) - Bumper metric dimensions to be 1600.2mm x 114.3mm x 254mm (LWH)

• AD-1 (for anchorage to lower dock face)
• AD-2 (for anchorage to dock floor)
• AD-3 (for anchorage to dock floor and dock face)
• AD-T (for anchorage to curb angle and dock face)

Anchor Diagram

• 90° angle on both ends (Standard)
• Flat plate on right (Weld on application)
• Flat plate on left (Weld on application)
• Flat plate both ends (Weld on application)

10 in High x 63 in Long x 4.5 in Thick

Wedge Anchors sold separately.